Only $549! Regularly $1099! You Save $550!
Certified Pre-Owned! Fully Tested & Inspected!
Hurry, Only 1 Available. Won't Last Long!
90 day warranty included! Satisfaction Guaranteed!
This item not eligible for any further discount offers!
*Special Note: There is a small defect on the front left of the plinth (pictured). Platter has very small chips, scuffs and wear (pictured). Top of Dust Cover has normal use light scuffs. .
Limited edition audiophile turntable with acrylic chassis and class-leading sound!
2Xperience Primary Acryl is an ultra-stylish record player that uses advanced technology for great sound. A quiet running AC motor with a two-step pulley drives the platter's outside edge via a belt. The resonance-optimised MDF platter runs on a low-tolerance stainless-steel axle with Teflon bearing plate in a sintered bronze bearing housing. The transparent acrylic plinth stands on three height-adjustable TPE-damped aluminium cones. An external power supply avoids potential electro-mechanical interference.
The sophisticated 9" tonearm uses an one-piece aluminium headshell & armtube and an inverted bearing design with four hardened ABEC7 spec ballraces. The solid armbase permits accurate height adjustment of armtube and VTA (vertical tracing angle) if needed. The internal wiring consists of flexible high-purity copper from the headshell right through to the gold-plated phono sockets.
Principle: Belt Drive
Nominal speeds: 33/45 rpm
Signal to noise: -65dB
Effective tonearm length: 9" (230mm)
Effective tonearm mass: 15g
Power consumption: 5W max/ >0,5W standby mode
Dimensions: 18.3" x 5.12" x 13.39" (W x H x D)
Weight: 14.33 lbs
Output voltage at 1000 Hz, 5cm/sec.: 5,5 mV
Channel balance at 1 kHz : 1,5 dB
Channel separation at 1 kHz: 22 dB
Channel separation at 15 kHz: 15 dB
Frequency range at - 3dB: 20-22.000 Hz
Frequency response: 20-20.000 Hz + 3 / - 1 dB
Tracking ability at 315Hz at recommended tracking force: 70 µm
Compliance, dynamic, lateral: 20 µm/mN
Stylus type: Elliptical
Stylus tip radius: r/R 8/18 µm
Tracking force range: 1,6-2,0g (16-20 mN)
Tracking force, recommended: 1,8 g (18 mN)
Tracking angle: 20°
Internal impedance, DC resistance: 1,3 kOhm
Internal inductance: 700 mH
Recommended load resistance: 47 kOhm
Recommended load capacitance: 150-300 pF
Cartridge colour, body/stylus: Black/Red
Cartridge weight: 7,2 g
Replacement stylus unit: 2M Red (interchangeable with 2M Blue and 2M Silver)